Stamping Briquette Machine

Introduction

Jiutian biomass briquette machine mechanical stamping design, By using the principle of high temperature and high pressure, the pressure angle can be adjusted automatically, Smooth operation, ensure the stability of the material forming.has large capacity, can 24 hours continuously work, high productivity, stable performance. Mechanical stamping design, with the high temperature, high pressure, high frequency working principle, the briquette density can be protected. High degree of automation, simple operation, less labor.

The briquette machine has wide applicability for Agriculture, forestry waste, domestic waste, etc. Such as plant straw, grain, peanut shell (shell), cotton stalk, sawdust, sawdust, branches, bark, bamboo powder, furfural residue and garbage etc. The raw material moisture should be about 15%, the raw material length should be less than 15mm. Stamping type briquette machine has multifunctional design can produce different kinds of pellet and briquette, such as φ8mm, φ10mm, φ22mm, φ30mm, φ55mm, φ65mm, φ70mm, φ85mm,etc. Just need change the mold. 

On the basis of similar equipment, the technical content and function of our company briquette machine has improved a lot, In terms of price, we fully consider the economic affordability of the majority of users. In particular, the requirements processing costs for farmers. 

Working Principle

The main motor is driven by the eccentric wheel to move 280 times per minute, the screw feeding machine start to feed the raw material, the the raw material will feed into the briquette machine feeding box by the depiler. Then the raw material will into the press room by the screw from the left and right sides, the raw material will be pressed by the punch and mold, Begin to heating-up, soften, the volume becomes smaller, Because of the taper of the forming mold, The raw material which has been impacted by many times then begins to harden and harden, and is gradually discharged from the mold, the briquette machine used the crank slider stamping principle, crank slider will press 280 times per minute when normal operation, the pressure can reach 300 tons, temperature can reach 150-200℃, then the briquette machine has strong adaptability, good molding density, Each rotating or sliding parts are forced lubricated by oil pump, can improve the service life of rotating or sliding parts.

Technical Parameters